Datsun Roadster Rocker Panel / Sill End Cap repair section
This section is accurately shaped to replace the bottom section of your rocker panel at the front, where the front guard is bolted on. It also gives you the ever so important front guard locating position.
If you request the section for the rear, where the quarter panel wraps over it, there will be no locating nuts.

Please specify which side, and front or rear.
The section is approx. 300 mm long, 35 mm passed the panel joint, and 30 mm in height.
Cost AU$ 195.00 each (includes 10% GST)
Note: Shipping cost to be added.

Datsun Roadster Rocker Panel / Sill End Cap (Rear)
Same length as the Front End Caps. The End Caps come without gussets and without mud guard locating nuts, as per original.
Cost AU$ 288.00 each (includes 10% GST)
Note: Shipping cost to be added.

Datsun Roadster Front Center Panel (Apron with large vent holes)
This panel has been hand made to original specs. The fog light stiffener gusset has been slightly enlarged to stop the fatigue cracks around the base of the fog lights.
This panel can be used on all roadsters. It is designed to allow more air to hit the radiator.
The item will be sold with red oxide primer applied

Cost AU$ 390.00 each (includes 10% GST)
Note: Shipping costs to be added

Datsun Roadster Rocker Panel / Sill End Cap (Front)
Sill End Caps are 420 mm long, and come complete with internal gussets and front mud guard locating nuts.
Note: The gussets are supplied but not welded into the End Caps.
Cost AU$ 339.00 each (includes 10% GST)
Note: Shipping costs to be added.

Datsun Roadster Jacking Point Internals
Ready to be welded into place.

Price: AU$ 209.00 each (includes 10% GST)
Note: Shipping costs to be added.

Datsun Roadster Rocker Panel / Outer Sill Panel,
without Jacking Internals
Complete outer sill panel with internal gussets, recess for cover cap of jacking hole, and front mud guard locating nuts (jacking internals not included).

Price AU$ 1313.00each (includes 10% GST)
Note: Shipping costs to be added.

Datsun Roadster Complete Rocker Panel / Outer Sill Panel
Complete sill panel with jacking internals, gusset, recess for Jacking hole cover cap,
and front mud guard locating nuts.
The Rocker Panel / Sill Panel is a hand made reproduction, the sheet metal is formed/shaped over a bronze "buck" taken off an original rocker panel. This method guarantees the highest level of accuracy.

Price AU$ 1569.00 each (includes 10% GST)
Note: Shipping costs to be added